OK, first the banging and force pulling method is OUT !!!! All of the Bravo/a seat head rests can be removed whit ease. You only need these pliers (don’t know the right name ;) ) The next step is to pull up the head rest and grip the pins whit these pliers.
WARNING : Put some […]

• 0 Comments

This guide will show you how to renew your old existing Bonnet Pin and Lock. Please read this guide through at least once before fitting.
Step 1. (Optional) Preparation prior to fitting
Before you start removing your old parts you may want to consider preventing your new parts from corroding like the existing ones. You could smear […]

• 0 Comments

Open the arm rest and you will notice 4 allen key bolts and the catch bolt on the under side off the arm rest Undo the catch bolt usin either a pair of plyers or relevant size spanner, use allen keys to remove the remainin 4 allen key bolts. Then remove the plastic body away […]

• 0 Comments

The first thing you need to do is jack up the car and remove the wheel. After you have done that, you will be left with this. Now the first step in removing the caliper is to take off the spring on the front side. You do it using some pliers. The yellow arrow shows […]

• 0 Comments

The first step is to locate the MAF sensor. Its position is on the air intake system, after the air filter box.
The second step is to unplug the connector on the MAF sensor. It has a clip that holds it firmly in place, so you need to push the clip with your finger to release […]

• 0 Comments

How the clip looks is circled with a red circle and where the clips are positioned, is pointed out with red arrows. First you need to take off the door card, here is a short reminder of where the screws are. After you have removed the door card and the protective sheet, you have to […]

• 0 Comments

The first thing I bought a chinch (pic.1) to headphones (pic. 2) cable. Taken the glove box out and the Fiat radio. Fitted the connection cable and 1 two line cable for power (pic.3), had the hole in the dash when I bought the car (prob. a mobile phone holder) Connected the two line cable […]

• 0 Comments

The first step is to remove the old (bravo) console. You do it like so. First remove the clips and screws near the front end of the console on its sides (circled red) Then remove the rubber in the “shelf“ of the bravo console using a knife or a small screwdriver and lift it up. […]

• 0 Comments