To understand how you can use ePipe refer to the ePipe 2344 ML-IP Gateway User Guide on the ePipe ML-IP Family Software & Documentation CD. This user guide is also available from the ePipe web site (www.ml-ip.com). Quick Setup The ePipe 2344 can be connected to a variety of devices via its 10/100Mbps Ethernet (10/100Base-T) interfaces and its RS-232 asynchronous serial ports. Apart from Ethernet 1, all Ethernet and serial ports can be used to connect the ePipe 2344 to an Internet or WAN connection. 2

Step 2: Connecting the ePipe 2344 to your LAN NOTE: Ethernet 1 must be connected to the internal or private network. The Configuration PC must also be connected to this network. The ePipe 2344 has four 10/100 Mbps Ethernet ports (10/100Base-T). ! What Else Do I Need? Before installing the ePipe 2344, you will need the following: Ethernet 1 must be connected to the internal LAN or other local network as all configuration of the ePipe 2344 occurs via this interface. Figure 1 shows a typical network deployment using ePipe 2344 units to connect two sites. Remote Site Head Office To connect the ePipe to your LAN, follow the steps below: LAN - Microsoft Windows (XP or 2000 recommended) - Microsoft Internet Explorer 5 or above ePipe 2344 Modems (PSTN or ISDN) Internet / Other Network Access Router (e.g. T1, Frame Relay) LAN • A PC connected to your LAN for configuring the ePipe 2344, referred to as the Configuration PC, running the following: Configuration PC xDSL Modems ePipe 2344 1. Attach Ethernet 1 on the ePipe 2344 to an internal or DMZ LAN. Using the provided Ethernet UTP cable (green connectors), connect one end of the cable to Ethernet 1 on the ePipe 2344 and the other end of the cable to an available port on your LAN’s hub or switch. If using a 3rd party cable, use a standard straight-through Cat5 (or better) patch lead. Configuration PC Existing LAN Hub or Switch

Download pdf ePipe 2344 ML-IP Gateway Getting Started Manual Guide