Documentation Introduction Protocol Support Addresses and Port Number Serial RS232 Interface USB Interface Power Supply Ethernet Interface LEDs Product CD Technical Specifications Getting Started Physically Connecting the Unit Install USB Device Drivers NETUSB Software Interface Virtual COM Port Driver Installation Windows 2000 Virtual COM Port Driver Installation Windows XP Virtual COM Port Driver Installation Windows 98 SE Virtual COM Port Driver Installation Linux 2.40 Methods of Assigning the IP Address Hardware Address IP Address DHCP AutoIP Device Installer Install Device Installer RUN Device Installer Device Found Assign IP Assignment Using Device Installer Viewing the Current Configuration

Configuration Using Web Manager Accessing XPort Using Device Installer Network Configuration Automatic IP Address Configuration Static IP Address Configuration Ethernet Configuration Server Configuration Host List Configuration Channel 1 Configuration NET232/NETUSB User Guide Connection Settings - TCP Connection Settings - UDP1 Email Settings Trigger Configuration Configurable Pin Settings Apply Settings Apply Factory Defaults Configuration Using Telnet or Serial Port Using the Serial Port Using a Telnet Connection Telnet and Serial Port Messages Server Configuration (Network Configuration) IP Address Set Gateway IP Address Netmask: Number of Bits for Host Part Change Telnet configuration password DHCP Naming Channel 1 Configuration (Serial Port Parameters) Baudrate I/F (Interface) Mode Flow Port Number Connect Mode Send the Escape Sequence (+++) in Modem Mode Auto Increment Source Port Remote IP Address Remote Port DisConnMode Flush Mode (Buffer Flushing) Pack Control DisConnTime (Inactivity Timeout) Send Characters Telnet Terminal Type Channel (Port) Password E-mail Settings E-mail Setup Trigger Setup Expert Settings TCP Keepalive time in seconds ARP Cache timeout in seconds Enable High Performance Disable Monitor Mode at Bootup RS-485 TX Enable Active Level HTTP Port Number SMTP Port Number MTU Size Enable Alternate MAC Ethernet Connection Type Security Settings Disable SNMP SNMP Community Name NET232/NETUSB User Guide Disable Telnet Setup Disable TFTP Firmware Upgrade Disable Port 77FE (Hex) Disable Web Server Disable Web Setup Disable ECHO Ports Enable Encryption Enable Enhanced Password Disable Port 77F0 (Hex) Defaults Exit Configuration Mode Updating Firmware Obtaining Firmware Reloading Firmware Via Device Installer Troubleshooting Technical Support Monitor Mode Monitor Mode Entering Monitor Mode Using the Serial Port Entering Monitor Mode Using the Network Port Monitor Mode Commands List of Figures

Download pdf GridConnect NET232/NETUSB Serial to Ethernet Adapter Users Manual