This guide shows how to install the portable SCSI Jaz drive on a Macintosh. If you encounter any problems while installing your Jaz drive, refer to the “Troubleshooting” section in the Jaz User’s Guide. Unpack the Jaz drive and accessories. Data Cable Jaz Drive 50HD to 25D Cable Converter Jaz “tools” Disk (contains Jaz Tools software) Manuals and Install Diskettes* External Power Supply 1GB 1GB tools * You will not need an install diskette to install Jaz Tools on your Macintosh. Shut down your Mac, turn off all connected devices, and pick up the Jaz data cable.

WARNING Always turn off power to the computer and all devices connected to it (such as printers or drives) before beginning any computer hardware change. M 1 Connect one end of the data cable to either SCSI port on the back of your drive, and PUSH until connector locks into place. (If the connector does not go on easily, try turning it over.) Jaz Connector 4 I A O I SCSI ID Term 0 PWR DO NOT attempt to stand the Jaz drive CAUTION on its side! NEVER move the drive when in use! M To Remove the Jaz Data Cable: Squeeze the spring locks on both sides of the data cable connector while pulling on the connector. M Use the 50HD to 25D cable converter to connect the other end of the data cable to the built-in SCSI connection on your Macintosh. 4 I A O I SCSI ID Term 0 PWR PowerBook Users You need a special PowerBook cable to connect the Jaz drive. Check with your Iomega dealer or call Iomega at 1-800-MY-STUFF to order a Jaz PowerBook cable. 3 2 4

Download Jaz 1GB External Installation Guide for Macintosh pdf