This Guide Purpose and Audience Chapter Summary Additional Documentation 2: Introduction Protocol Support Addresses and Port Numbers Ethernet (MAC) Address IP Address Port Numbers Logon Methods3: Getting Started 3-1 Physically Connecting the Unit Required Information Hardware Address IP Address Using DeviceInstaller to Assign an IP Address Installing DeviceInstaller Assigning an IP Address Using Web-Manager to Configure the Unit Unit Configuration Server Properties Port Properties Serial Port Settings Connect Mode Settings Dedicated Connection Flush Mode Input Buffer Packing Algorithm Additional Settings Factory Settings

Update Settings 4: Using Setup Mode for Configuration Accessing Setup Mode Using a Telnet Connection Using the Serial Port Server Configuration (Network Configuration) IP Address Set Gateway IP Address Netmask: Number of Bits for Host Part Change Telnet Configuration Password DHCP Name Channel 1 Configuration (Serial Port Parameters) Baudrate I/F (Interface) Mode Flow Port Number Connect Mode Remote IP Address Remote Port DisConnMode Flush Mode (Buffer Flushing) Pack Control DisConnTime (Inactivity Timeout) Send Characters Telnet Terminal Type Channel (Port) Password Expert Settings TCP Keepalive time in seconds ARP Cache timeout in seconds Security Settings Disable SNMP SNMP Community Name Disable Telnet Setup Disable TFTP Firmware Upgrade Disable Port 77FE (Hex) Enable Encryption Disable Web Server Disable ECHO Ports Enable Enhanced Password Factory Defaults Expert Settings Security Settings Exit Configuration Mode 5: Updating Firmware Obtaining Firmware Reloading Firmware Via DeviceInstaller Via TFTP Via Another Unit Via the Serial Port Serial Port Recovery Procedure 6: Monitoring the Network Entering Monitor Mode via the Serial Port Entering Monitor Mode via the Network Port Monitor Mode Commands 7: Troubleshooting Problems and Error Messages Technical Support

Download pdf Lantronix Embedded Integration Kit Users Manual