The rear panel calibration adjustment allows you to fine tune the BCS for your vehicle. If the setting is too high or too low, your car will not make full power. After the BCS is installed, the rear panel adjustment can be set during a short test drive. Start with the setting on maximum (100). See if the car pulls strongly to redline. Turn down the setting until the cars pulls strongly to redline in all gears. If the cars surges (cyclic variation in power), turn down the setting a little bit.
Read the rest of this entry »

• 0 Comments

1990 Wiring Diagrams Audi 100
COMPONENT LOCATION MENU
COMPONENT LOCATIONS TABLE
??????????????????????????????
Component (Figure No.) Location
A/C COMP ………………………………….. 3 (D 8)
A/C CONTROL HEAD ………………………….. 3 (D 10)
A/C HI PRES SW ……………………………. 4 (E 12)
A/C PROGRAMMER ……………………………. 3 (E 11)
A/C RELAY …………………………………. 3 (D 8)
ABS SYSTEM …………………………… 6 (A-C 20-23)
AIRBAGS WARNING LT ………………………… 5 (B 19)
AIRBAGS ……………………………… 5 (B-C 18-19)
ALTERNATOR ………………………………… 1 (B 3)
ANTI-THEFT SYSTEM …………………….. 8 (D-E 28-31) Read the rest of this entry »

• 0 Comments