You will learn how to install the Neo iON in specific vehicles. Acura Before connecting any cables to the black box you must set the dip switch to the Chrysler New / Honda / Acura position. If you set the dip-switches after you have connected cables to the box, you must disconnect and reconnect them for the iON to operate. Audi Make sure you have your radio’s theft protection code before you attempt installation. When you reconnect power to the battery, you will need to enter this code. Information about the theft protection code can be found in your vehicle’s audio operation manual. Before connecting any cables to the black box you must set the dip switch to the Audi position.
Read the rest of this entry »

• 0 Comments

Installation Preparation (All Vehicles) 1 Anti-Vibration Setup 2 Load/Unload Magazine 3 C H A P T E R 2 Dip-Switch Overview (REQUIRED) 5 Acura 6 Audi 7 Ford (Ford, Lincoln, Mercury) 8-9 GM (Buick, Cadillac, Chevy, GMC, Oldsmobile, Pontiac, Saturn) 10-11 Chrysler (Jeep, Dodge, Plymouth, Eagle) 13 Honda 14 Toyota 15 Volkswagen 16 C H A P T E R 3 Troubleshooting 17 Warranty/Warnings 18 FCC and Legal Information 19 Installation Preparation This chapter provides information required for the installation of the Neo Changer, it must be read by all users. Thank you for purchasing the Neo Changer. Since the Neo Changer will works in many different vehicles the following steps must be taken to ensure the changer is set up correctly for the vehicle it is being installed in. Before Installation To prevent damage to your vehicle and the changer take the following precautions. 1. Turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the vehicle is equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the battery cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution to avoid causing a short circuit during installation. If your radio has a security code make sure you know the code and how to enter it prior to removing the battery cable. The radio will require this code to operate when the battery terminal is reconnected.
Read the rest of this entry »

• 0 Comments